Before the start of the paint work need to stock up on a roller and a bucket or tray, in which the squeezing set grid. This simple device will help to remove excess paint. You can use the classic baths, as shown to the left. roll performance is much higher, performance than the brush. It can be used for priming and painting the lime, glue and oil paint. How to do it, site renovated apartment with his hands Now tell.
Steel may be used for the manufacture squeezing grid, plastic or plywood. It should be drilled at a distance 20 mm from each other in a staggered diameter holes 12-15 mm.
You do not get paint roller wall corners near plinths, casings, etc.. d. Therefore, in places previously well stained brush. Important, prvilno choose nap roller of this result depends.
Staining technique roller wall and ceiling
staining technique is simple and as follows. Dip into the paint, then, to squeeze out excess, rolled across the grid. Now you can start painting. On the walls, roller are top-down and bottom-up, on the ceiling - in the direction of light rays. Strip paint overlaid, overlapping each other in 4-5 cm. After dipping in the paint, first roller causes the thick layer, so you need some time to roll in one place. Then, the ink on it is spent, and the need to increase pressure on the tool.
The walls can be coated in one step vertical stripes or two Hour, first causing vertical streaks, and then horizontal. Trying to paint a good shade. The quality achieved by applying more layers .
Important! When painting a ceiling or wall, Finishing move the roller in one direction, as it were structuring the paint in one direction. Due to this ceiling does not glare and the paint falls more clearly without promiscuity.
Sometimes the paint is applied with a brush, well feathered, and then rolled roller, to smooth out and get a uniform paint.
With a roller, you can not just paint the walls and ceiling, but also to apply primer on the surface.
Roller much more productive tool, than brush: it is possible to paint the day before 300 m surface. He has a great life. If it is made of high quality fur, then it will be enough to paint 3000 m different surfaces.
After the end of the roller must be washed in water , and then with soap and water - depending on, what paint was used. And from lime composition, and from the remnants of oil paint is not washed tool comes into disrepair. Do it right and it will serve you for a long time. Find out how much paint you'll need, It helps free ink consumption calculator.
