Video trim plastic panels with their own hands

: Video renovated apartment, repair manual. Finishing plastic panels the walls and ceiling with his hands video lessons.

At the moment, this type of trim is one of the most economical. Also cladding plastic panels used to align the walls or ceiling. Decorating the walls with plastic panels suitable for any premises, and the video will help you understand. Plastic does not need special care, surface, sheathed with plastic, simply wipe with a damp cloth from time to time.

Before starting work, you must determine the color and the amount of material. Make all the measurements and the room, assuming, that the panels have a size 0,5 m * 3 m, Calculate the right amount. The panels come in other sizes, so it is advisable to go to the store, which will buy materials, and clarify all sizes. The number of connecting profiles (moldingov) too should calculate in advance. All the necessary materials should be taken with a small margin.

The panels are fixed to the wooden crate. Therefore, you must first decide, as a panel will be located - either vertically or horizontally. If vertically, the pieces of wood attached to the wall vertically with a pitch 0,5 m. Then they fixed horizontal bars (3 PC.). If horizontally, and the lower horizontal bars with a pitch 0,4 m. Furring elements produce measurements and counting the desired number. Reiki is better to buy a length not less than the height of (or length) walls. Suitable section bars - 4 cm * 2 cm or 6 cm * 4 cm. The wooden frame is mounted to the wall with dowels and screws or with nails. Each element must be sure to check the building level, especially if the walls are very curves. Finishing plastic panels with their hands hiding irregularities, but to put bars to do this equals.

Set the start molding, if the ceiling is not applied, in top and bottom walls. then a corner, External or internal, depending on where the cladding is being. After all the profiles begin installation panels. slightly bent, the panel is inserted into the starting profiles, and then all the way to the corner. It is imperative to check the specified grade levels. Attach the panel is possible by means of metal holders. After installing the blade holder is inserted into the edge of the panel and nailed to a wooden frame. Also you can use for fixing brackets or screws. In this way, installed all the panels to the corner. In the corner again set the corner profile, and so on. d.

When facing the kitchen, installation should be carried out with a small gap between the panels, t. to. temperature control in the kitchen is not stable. A significant increase in temperature when the plastic will expand. And now look at the video and anchoring material.